10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CLEANING, MAINTENANCE & STORAGE
The pump should require no maintenance other than regular cleaning.
1. Inspect the pump prior to use and do not use the pump if there is any
damage to the mains power cable.
2. Check pump regularly to ensure the inlet is clear of leaves or other debris. It
can be cleaned out either by back-flushing or by removing the base plate
(after undoing the retaining screws) and cleaning out by hand.
3. Take extra care to remove any debris from around the impeller.
4. If the pump has been used for pumping swimming pool water or salty
water likely to leave chemical residues, it should be flushed through with
clean water before storage.
5. When the pump is not being used for extended periods, clean and dry it
thoroughly and store in indoors. if the pump is left in water, it should be run
at least once a week to prevent it from seizing up.
6. If the pump shows signs of wear or damage, contact your CLARKE dealer
for advice. Do not attempt to repair the pump yourself, as you may
damage the waterproof seals and invalidate your guarantee. Repairs
should be carried out by your local CLARKE dealer, or contact the CLARKE
Service Department on 020 8988 7400.
USEFUL ACCESSORIES FROM THE CLARKE CATALOGUE
Hoses, clips and other items are available from your CLARKE dealer.
WARNING: MAKE SURE THAT THE PUMP IS DISCONNECTED FROM THE
POWER SUPPLY BEFORE CLEANING OR PERFORMING MAINTENANCE
Hoses
Hose Clips
•
Available in 100 metre coils or per
meter.
•
Zinc plated for corrosion
resistance.
Summary of Contents for 7230296
Page 16: ......