28
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Place a piece of heavy flat bar
stock or a heavy metal ruler
approximately 12" long across the
finger receiver, as shown in Figure
46.
4. Lower the brake fingers until one
just rests on the metal bar, as
shown in Figure 46.
5. Starting at one end, visually check
the gap between the brake
fingers and the metal bar.
6. If you find a gap at one end of the brake, loosen the cap screw shown in
Figure 46 on that end, then turn the adjustment bolt counterclockwise until
the gap disappears.
7. Re-tighten the cap screw, remove the metal bar and use the hand crank
to cycle the machine 2-3 times.
8. Repeat Steps 3-7 until the brake fingers rest evenly on the metal bar along
its entire length.
Fig. 46
Summary of Contents for 6560005
Page 36: ......
