17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
TROUBLESHOOTING
Problem
Check
Solution
Motor stops and
will not run.
1. Defective/broken on/off
switch.
2. Damaged power cable.
3. Open circuit, loose
connections or burned out
motor.
4. Blown fuse or circuit breaker.
5. Low voltage.
Send to your CLARKE dealer
for repair.
Send to your CLARKE dealer
for replacement.
Send to your CLARKE dealer
for replacement.
Replace fuse or re-set circuit
breaker. Turn off other
machines on same circuit.
Check the power supply for
correct voltage. Use
another circuit or have a
qualified electrician
upgrade the power supply.
Motor will not start
and fuses or
circuit breaker trip
out.
1. Short circuit in motor or
power cable.
2. Incorrect fuses or circuit
breakers.
Send to your CLARKE dealer
for repair.
Replace with correct fuse or
circuit breaker for the circuit.
Motor fails to
reach full power.
1. Overloaded circuit.
2. Unsuitable extension cable
Turn off other machines &
retry.
Replace with correct size
extension cable.
Noisy operation
1. Incorrect belt tension.
2. Dry spindle.
3. Loose drive pulley.
Adjust belt tension. See
Replacing the Belt on page
12
Lubricate the spindle.
Tighten the retaining set-
screw on the pulley.
Summary of Contents for 6501661
Page 20: ......