11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE BELT POSITION
The lathe is fitted with a 3-step pulley assembly,
which allows for a range of speeds as shown.
Change the pulley range as follows.
NOTE:
Make sure that the lathe is unplugged from
the power supply.
1. Unlock the control box and swing to the side for
access to the motor pulley.
2. Unscrew the rear belt door on the rear of the
headstock for access to the drive pulley.
3. Loosen the lock screw that is holding the motor
plate using the 6mm hex key. Allowing the motor
plate to swivel upwards.
4. Move the belt to the required
pulley, as shown in the diagram
above.
NOTE:
Always go from the large
pulley to the small pulley
5. After moving the belt, tighten the
motor pulley by swiveling the
motor plate downwards and
tightening the locking screw.
6. Turn on the lathe to make sure the
belt is running consistently in its
parallel grooves on the pulleys.
WARNING: KEEP HANDS AND ANY
MATERIAL CLEAR OF ROTATING PULLEYS
AND BELT
7. If belt is running smoothly, then
turn power off, reattach the
control box and rear belt door.
Summary of Contents for 6501661
Page 20: ......