9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5. To remove a bit pull back the locking sleeve and pull the bit out of the tool
holder.
NOTE:
The supplied dust shield cap can be placed over the shaft of the
bits before inserting it into the SDS chuck this is used when drilling
overhead to prevent dust or debris entering the drill vents.
USING THE KEYED CHUCK
1. The keyed chuck is inserted in the
same way as SDS Bits.
INSERTING A NORMAL DRILL BIT INTO CHUCK
1. Open the chuck by rotating the
chuck sleeve anticlockwise until
the jaws are open sufficiently to
take the drill bit.
2. Place the drill bit in the jaws of the
chuck as far as it will go.
3. Insert the chuck key in one of the
three holes in the chuck and
tighten in a clockwise direction.
• Make sure the head of the
chuck key is firmly located on the cogged barrel of the chuck when
tightening.
4. To remove the bit, release by inserting the chuck key in one of the holes
and turning in an anticlockwise direction.
CAUTION: TO PREVENT DAMAGE, DO NOT USE THE HAMMER DRILL
MODE WHEN USING THE KEYED CHUCK.
WARNING: REMOVE THE CHUCK KEY BEFORE OPERATING THE DRILL.
Summary of Contents for 6479510
Page 16: ......