11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE AND SERVICING
GENERAL MAINTENANCE
1. Check that the power cable is free from cracks, bare wires etc. Avoid using
solvents when cleaning plastic parts. Most plastics are susceptible to
damage from solvents.
2. Ensure all screws remain tight to ensure the jigsaw is in safe working
condition.
• All bearings etc, in this machine are lubricated with a sufficient
amount of high grade lubricant for the tools lifetime under normal
operating conditions, therefore no further lubrication is required.
• Only use the replacement blades specified for this product
available from your CLARKE dealer.
3. After use, clean all dust and wood dust from the saw. To ensure constant
air circulation, always keep air vents clear of blockages, (use compressed
air to clean the machine if possible. (Wear PPE when using compressed
air).
4. Keep the sole plate free from dirt and grime. Regularly clean to prevent
scratches and scores on the surface.
5. Resin and glue on the blade causes poor cutting results. If necessary clean
the blade after use.
6. Refer to your CLARKE dealer if internal maintenance is required.
REPLACEMENT BLADES
Replacement blades are available from your CLARKE dealer as follows:
Wood - 6462196 (pack of 5)
Metal - 6462198 (pack of 5)
WARNING: BEFORE PERFORMING ANY MAINTENANCE TASKS ENSURE THE
PLUG HAS BEEN REMOVED FROM THE MAINS SUPPLY.
Summary of Contents for 6462183
Page 16: ......
