23
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Replace the pump and slide the tank back into the base unit.
5. Replace the return hose back into the hole with the swarf screen basket.
USING THE CUTTING LUBRICANT
1. Check that there is sufficient lubricant in the tank and the pump inlet is
submerged.
1. Adjust and set the bandsaw up to
cut the required item.
2. Turn the lubricant pump on and
adjust the lubricant control valve
to the desired feed rate.
3. Turn on the bandsaw and
commence cutting.
NOTE:
When the bandsaw is not in
use for long periods or needs
transporting, it is
recommended that you empty the lubricant tank.
MAINTENANCE
GENERAL
Remove all accumulated swarf from inside the bandsaw frequently using a
soft brush and/or vacuum cleaner. Alternatively, if compressed air is used,
ensure it is set to no more than 10 psi and wear protective safety glasses.
Maintain a thin film of oil on all unpainted surfaces including all screw threads
to protect your saw from corrosion.
For optimum performance from your machine, follow this maintenance
schedule and refer to any specific instructions given in this section.
DAILY CHECK:
•
Loose mounting bolts
•
Damage to saw blade
•
Worn or damaged wires
•
Any other unsafe condition
WARNING: ALWAYS SWITCH OFF AND DISCONNECT FROM THE POWER
SUPPLY BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE
TASKS.
Summary of Contents for 6460123
Page 44: ......
