21
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BLADE GUIDES
The blade guides should be positioned approximately 1/4” away from the
workpiece if possible. This will help ensure straight cuts by keeping the blade
from twisting and drifting off the cut line.
To adjust the blade guides:
1. Loosen the blade guide knob as
shown.
2. Slide the blade guide as close to
the workpiece as possible.
3. Tighten blade guide knob.
FEED RATE
The speed at which the saw blade will cut through a workpiece is controlled
by blade type, feed rate and feed pressure.
To set feed rate:
1. Raise the bow to maximum height to
remove spring tension. Close the ON/
OFF valve on the hydraulic cylinder to
lock bow in place.
2. Adjust feed pressure tension spring by rotating the adjustment nut, as
shown. Tighten enough to remove play but not enough to apply tension to
spring.
NOTE:
This spring adjustment is an initial setting. Depending on cutting
circumstances, you will have to fine tune the feed pressure with
this adjustment. Increasing the spring tension will reduce the feed
pressure.
Summary of Contents for 6460123
Page 44: ......
