✗
NEVER
stand on the machine. Serious injury could occur if the machine is tipped
over. Do not store materials above or near the machine such that it is necessary to
stand on the machine to get to them.
✗
NEVER
operate a machine when under the influence of alcohol, drugs or medication.
✗
NEVER
force the machine. It will do the job better and safer, at the rate for which it
was designed.
Additional Safety Rules For Bandsaws
WARNING!
This machine must not be modified or used for any purpose other than that
for which it is designed.
✔
ALWAYS
wear suitable eye protection, manufactured to the latest European Safety
Standards, when using the bandsaw.
✔
ALWAYS
Ensure the proper electrical regulations are followed, and that the machine is
properly earthed.
✔
ALWAYS
ensure all spanners, wrenches etc., are removed from the machine before use.
✔
ALWAYS
ensure the workpiece is properly secured using the vice...NEVER hold by hand
when cutting, unless using the vertical cutting table.
✔
ALWAYS
make adjustments with the power OFF.
✔
ALWAYS
cut at correct speed for the type of material being cut.
✔
ALWAYS
keep your hands and fingers clear of the blade when sawing.
✔
ALWAYS
set the blade guide/guard assembly as close as possible to the workpiece.
✔
ALWAYS
switch off the saw, and make sure the blade has come to a complete stop
before examining or removing the workpiece.
✔
ALWAYS
keep the saw properly adjusted, paying particular attention to the blade
tension and the blade guides.
✔
ALWAYS
disconnect the saw from the mains supply before removing the blade cover.
✔
ALWAYS
check the coolant DAILY. Ensure it is clean and of the correct mix.
✔
ALWAYS
Wipe the machine surfaces dry at the end of the day.
✔
ALWAYS
disconnect from the power supply before carrying out any maintenance tasks.
✗
NEVER
operate this machine unless you are thoroughly familiar with it. If there is any
doubt whatsoever, you should consult a qualified person.
✗
NEVER
operate the machine until it is completely assembled, and this entire manual,
has been read and understood.
✗
NEVER
leave the Bandsaw unattended whilst it is running. Turn power OFF and Don’t
leave until it comes to a complete stop.
✗
NEVER
allow suds to enter the electrical system when using coolant
✗
NEVER
use soluble oil to cut Magnesium. See your industrial coolant supplier for specific
recommendations.
5
