20
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
VERTICAL CUTTING
To operate in the vertical cutting position, the table must be fitted and the saw
body locked in the vertical position.
LOCKING IN THE VERTICAL POSITION
1. Rotate the vertical locking
bracket to an upright position,
and locate in the notch on the
saw body.
2. If you have difficulty in locating
this bracket in the notch, adjust
the bracket securing bolt until the
bracket locates;- then tighten the
bracket securing bolt.
FITTING THE TABLE
1. Remove the screws from the
blade guide.
2. Attach the table support bracket
to the bolt as shown, but leaving
the bolt slack.
3. Set the table on top of the guide
assembly and insert screws A into
the guard.
4. Fit screw B (with the nut and
washer), into the bracket and
tighten fully.
5. When cutting, adjust the upper
blade guide so that no more
blade is exposed than is required
to cut the workpiece.
6. Keep hands well clear of the blade and use a push stick for small
workpieces.
7. Switch off immediately when cutting is complete.
Summary of Contents for 6460060
Page 28: ......
