12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SWITCH ASSEMBLY
On the left end of the machine is the
ON/OFF switch assembly, which is
hanging loose at this stage.
1. Connect the two earth wires (1)
extending from the back of the
switch assembly to the machine
bed using the screw and washer
provided.
2. Mount the switch assembly using
the two screws (2).
WORK STOP ASSEMBLY
The work stop is used to cut pieces of
equal length without having to
measure each piece individually. It
comprises two parts, the work stop,
and the mounting rod.
1. Push the rod into the hole in the
edge of the vice and secure with
the bolt provided.
2. Mount the work stop on to the
rod, with the flat face towards the
saw blade, and temporarily secure with the grub-screw supplied. Ensure it is
not pushed on too far, as it may interfere with the saw blade when the saw
is lowered.
HANDLE AND WHEELS
1. Fit the handle by passing the ends
of the handle through the
corresponding holes in the right
leg, and locating from inside the
leg using the split pins provided.
Summary of Contents for 6460060
Page 28: ......
