Clarke 6014530, Operating & Maintenance Manual

Page: 15 / 43

15
UNPACKING & PARTS IDENTIFICATION
Unpack and lay out the components, checking against the following list. Any
damage or deficiency should be reported to your CLARKE dealer immediately.
Most of the components are stored within the side compartment. To open the
compartment, put your finger in the hole in the side cover, and pull sharply.
1. Welder complete with Torch and Hose, Earth Cable with Clamp and Power cable.
NOTE:
Migs 151TE and 160EN are NOT provided with 13 Amp plugs. These machines MUST NOT be
connected to a standard 13 Amp domestic supply. See ‘Electrical Connections’ for full details.
2. 2 plastic feet + 2 Wheels w/Axle and 2 Lock washers. (110E, 110EN, - 2 Feet only)
3. 1xHandle Extension and Hand Grip ( NOT 110E, 110EN)
4. 1xHandle
5. 1x2-Piece Welding Mask
6. 1xWelding Mask handle, complete with plastic nut and 2xplastic screws.
7. 1xPackage containing 1x Clear Glass and 1x Dark Glass Lens
8. 1xMini Wire Spool, fitted to the Spool Holder
9. 1xplastic bag containing the following:
a1.
110E - 2xSpare Nozzles, 0.6/0.8mm (0.6mm fitted to torch)
a2. 110EN, 130EN, 160EN - 0.6/0.8mm (1.00mm fitted to torch)
a3. 135TE, 151TE - 0.8/1.0mm (0.6mm fitted to torch)
b. 2xScrews for fixing Handle
c. 4xSelf Tapping Screws with flat washers for fixing feet
d. 1xHex Wrench
e. 1xScrew for fixing Handle extension (110E and 110EN)
10. 1xDisposable Gas Cylinder CO
2 .
(NOT EN Models)
11. 1xGas Regulator (NOT EN Models )
12. 1xLarge Worm Drive Clip (NOT EN Models )
ASSEMBLY & INSTALLATION
A. Loose Components
Lie the welder on its side and attach the two feet using the four screws with flat
washers provided. For those models with wheels you have the option of fitting the
two feet, or the wheels as follows: Remove the plug covering the hole for the axle,
insert the axle, then attach the wheels, securing them by pushing the star locking
washers provided, on to the axle, using a piece of tube or an old socket, ensuring the
centre tines face outwards.
Attach the handle to the top of the machine by slotting it into place and securing with
the two screws provided. For those models with a handle extension, simply slide it into the
handle and secure with the screw provided.
The gas bottle is secured to the machine using the large worm drive clip which is threaded
through the opening provided on the rear panel of the machine, (NOT EN Models).