ELECTRICAL CONNECTIONS
! THIS APPLIANCE MUST BE EARTHED.
A. MIGs 110E, 110EN, 130EN, 135TE ONLY
These welders are fitted with a standard 13 amp BS 1363 plug, fitted with a 13 amp
fuse. Connect to a 230 volt (50Hz) domestic electrical supply and
we strongly
recommend that this be done via a Residual Current Device (RCD).
IMPORTANT: If the welder is fitted with a plug which is moulded onto the electric
cable (i.e. non- re-wirable) please note:
1.
The plug must be thrown away if it is cut from the electric cable. There is a danger of
electric shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code). Replacement fuse covers
can be obtained from your local dealer or most electrical stockists.
Fuse Rating
The fuse in the plug must be replaced with one of the same rating (
13 amps
) and
this replacement must be ASTA approved to BS1362.
B. MIGs 151TE and 160EN ONLY
Connect the mains lead, through a suitably fused isolator switch, to a 230 Volt
(50Hz) electrical supply, with a 15Amp fuse rating.
A standard 13 Amp plug MUST
NOT be used with these welders.
C. ALL MODELS
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow .......... Earth
Blue .......... Neutral
Brown .......... Live
As the colours of the flexible cord of this appliance may not correspond with the
coloured markings identifying terminals in your plug, proceed as follows:
•
Connect GREEN & YELLOW cord to plug terminal marked with a letter “E” or
Earth symbol “ ”, or coloured GREEN or GREEN & YELLOW.
•
Connect BROWN cord to plug terminal marked letter “L” or coloured RED.
•
Connect BLUE cord to plug terminal marked letter “N” or coloured BLACK.
Extension Cable
If an extension cable is fitted, ensure the minimum cross section of the conductor
is 1.5mm
2
for up to 15 metres in length, and 2.5mm
2
for up to 25 metres.
14
Summary of Contents for 6014530
