12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
STEP 6: INSTALLING THE MAIN COVER
1. Lay the cover on the ground next to the frame with the inside of the cover
(the side with the pockets) facing down and the strap on the front and rear
of the frame.
2. Tie a rope to the eyelets on the cover, one each side. Another rope in the
middle helps if another person is available.
3. Pull the cover over the frame using the rope as in Diagram K, making sure
to centre the cover on the frame. There should be an equal overhang on
each corner.
4. Assemble the ratchet tie-down #28) to the strap ends on the four corners of
the cover, one to each corner. Ratchet a few times to tension the strap.
5. Insert the hook on the ratchet into the hole on the bent corner leg. Wind
the ratchet so that the webbing overlaps itself.
6. Slide the bottom cross rails through the fabric pockets at each leg and re-
attach with clamps at each leg. Repeat this on the other side. Push down
on the cover rails to tighten the cover before tightening the bolts
completely.
7. When the cover rails are all secured, proceed to the four corners and
tighten the end covers to the end frames using the ratchet action.
Summary of Contents for 3503578
Page 16: ......
