7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
FITTING THE BLADE GUARD
1. Loosen the two table securing
knobs (Front and rear of the unit).
2. Tilt the table.
3. Slide the blade guard into position
as shown and secure using the
blade guard locking screws.
• The guard is held in position
between the frame and a small
bracket beneath.
FITTING THE BLADE
1. Remove the disc cover by
loosening the two screws shown.
2. Loosen and remove the disc fixing
nut. Using the two spanners
supplied.
3. Remove the outer flange.
4. Mount the disc on the arbor and
replace the outer flange. Turn the
disc 360 degrees to make sure it
matches with the flange properly.
• The direction arrow on the disc should point in the same direction as the
marking on the side of the disc guard.
5. Fully tighten the disc fixing nut and replace the disc cover.
WARNING: BEFORE USING YOUR TILE CUTTER BE SURE TO READ THE
INSTRUCTION MANUAL CAREFULLY.
Summary of Contents for 3400515
Page 12: ......
