Installation/Operation
1. Unpack the components carefully, and remove the protection foil, which cover most of the
outside surface. Make also sure that you have received the following pieces of equipment:-
• The main ABS body
• ABS tube with media
• ABS lid for the tube
• ABS lid for the foam cup
• A bag containing the associated nuts and bolts (transported inside the skimmer
body).
2. Before you assembly the unit ensure to make a proper foundation (concrete, wood etc.)
Recommended dimensions; 70 (width) x 90 (l) cm.
3. Install the 8mm adjustment bolts to the bottom PVC plate (threaded holes), the bolts should be
installed from underneath, with the washers and nuts supporting the PVC plate (the nuts
should be fastened when the installation is done).
4. Position the main body on the foundation.
5. Mark the position for the security bolts, and drill holes into the foundation (when the unit is
adjusted the security bolts should be fastened).
6. Fill the media in the bag into the tube and place it into the main body (the silver sticker should
be facing forward).
7. Pre-adjust the skimmer with the adjustments bolts. The units should be level sideways, as well
as slightly tilted forward.
8. Connect the Connecting tube to the Lid (11/2”, Female threads). To be able to adjust the water
flow, a ball-valve should be installed between the pump and the lid.
NOTE:
The Connection tube should not put any pressure on to the lid, so make sure to fasten the
connection tube with clips ( to fence etc.).
9. Remove the lid for the foam cup, start the pump, and wait until water appears at the front of the
Skimmer.
10. Adjust the right amount of water with the valve. Approx. 10000 l/hour.
11.Use the 2 front adjustment bolts in order to level the unit sideways. Then use the rear
adjustment bolt to make it lean slightly forward. Optimal effect of Clarity is achieved when the
water level, inside the foam cup, is 1mm (back) and 6 mm (front) (see Fig. 1).
12. When the unit is adjusted, fasten the security bolts.
13. Put the lid for the foam cup back on.
14. Make sure to lead the foam away from the water. Either a pipe or a flexible hose could be used
(the foam/waste outlet is 110 mm).
Congratulations - you have now installed and are running Clarity!
