VRX815
51
English
Installation and Wire
connection manual
7.
CAUTIONS ON WIRING
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the wires.
3. If the fuse should blow, check to see if the wir-
ing is correct.
If it is, replace the fuse with a new one with the
same amperage rating as the original.
4. When any fuse is to be replaced, pull out the
fuse (15A) at the rear of the tuner amp unit
and put in a new one (Fig.10).
After the connection, fix the lead by a clamp or
insulation tape for protection.
CAUTION
Rear view of the tuner amp unit
Fuse (15A)
Figure 10
1. When the rear of the main unit has been se-
cured with the method shown in Figure 6 un-
fasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab
B
of the
spring into hole
A
of the hook plate, then pull
6.
REMOVING THE MAIN UNIT
the main unit out by the hook plate. (Insert both
the right and left edges of the hook plate.) (Fig-
ure 9)
Note:
Keep the hook plate. You cannot remove the
main unit without disengaging the hook plate.
Universal mounting bracket
2-Hook plate
Outer escutcheon
Instrument panel
Spring
Main
Unit
A
B
Figure 9
Fuse
Fuse holder
Figure 11
5. To replace the fuse, release the catch on the
main unit side, remove the old fuse and insert
the new one. (Figure 11)
Note: There are various types of fuse holder. Do not
let the battery side touch other metal parts.
Summary of Contents for VRX815
Page 12: ...58 VRX815 Memo ...
