Clarion VRX815, Installation And Wire Connection Manual

Page: 4 / 12

50
VRX815
English
Installation and Wire
connection manual
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-installed
radio, install the main unit with the parts and
screws marked (
∗
). (Figure 8)
If the vehicle is not equipped with a factory-in-
stalled radio, obtain an installation kit to install the
main unit in the following procedure.
1. Remove the screws from both side of the main
unit. Then, at either side, lift the leaf spring until
the engaging claws are released from the
holes, and slide the spring to the direction of
■
Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
arrow to remove it. Repeat the same for the
other side to remove the springs from the both
sides. (Figure 7)
2. Secure the mounting brackets to the chassis
as shown in Figure 8. Holes are pre-tapped for
TOYOTA and NISSAN vehicles; modification,
such as drilling new holes, of the mounting
brackets may be required for other models.
3. Wire as shown in Section 8.
4. Secure the unit in the dashboard, and then
reassemble the dashboard and the centre
panel.
Note 1: In some cases, the centre panel may require
some modification (trimming, filling, etc.).
Note 2: If a hook on the installation bracket inter-
feres with the unit, bend and flatten it with a
nipper or a similar tool.
2-Screw
2-Spring
4-Hexagonal screw
∗
(M5
×
8)
Main Unit
Figure 7
Main Unit
Screwdriver
Engagin claw
Mounting bracket
∗
(1 pair for the left and right sides)
Pocket
Centre Panel (Note 1)
Note 2
Figure 8
∗
: The parts and screws with this mark
are used to install radio or included in
the installation kit.
★
: The parts and screws with this mark
are used to install radio or included in
the installation kit.