Page 6 - MS850 Installation Manual
In this configuration, the vehicle’s starter will be disabled while the system is armed and
alarming.
Pin 12 - **not used**
Pin 13 - RED/yellow: Parking Light (+/-) output [on-board relay, 7.5A Fuse]
Pr12v or ground (-) to flash the parking lights. See
Jumper Settings to select
polarity.
Do not connect this wire to parking light circuits that exceed 10 amps. For vehicles that
have independent left and right parking light circuits, the parking light wires must be
connected using diodes to keep the circuits separate.
Pin 14 - YELLOW/white: Auxiliary Function or Dome Light Control* (-) output.
This wire can be used to control either an auxiliary function (such as an electric trunk relase), the
drivers side door lock acutator (for Driver Door Priority mode),
or a dome light control relay.
Aux. Function. Provides negative (-) output. Output will stay on for as long as the
transmitter Button is pressed.
Dirver Door Priority. Operates a relay that unlocks only the driver door actuator when the
remote tranmitters are configured for Drivers Door Priority mode. See
Driver Door Priority
Wiring Diagrams.
Dome Light Control. Provides a negative (-) output to activate an optional dome light relay.
Do
not connect this wire directly to the vehicle’s dome light.
*See
Programming.
3-Pin Door Lock Harness
Pin 1 - WHITE/green: Door Lock (-) / Door Unlock (+)
Pin 2 - **not used**
Pin 3 - WHITE/blue: Door Unlock (-) / Door Lock (+)
These wires can be directly connected to negative and positive triggered door lock systems.
For Voltage Reversal systems and After-market actuators, add relays. For further
information, see
Door Lock Diagrams. For selection of Double Pulse output, Comfort
Closure, and 4-second pulse, see
Programming and Jumper and Switch Settings.
RED
WHITE
to alarm
VIOLET wire
to alarm
BLUE wire
to Starter
Solenoid
cut
VIOLET
to Ignition Key +12v
in “on” and “start”
BLUE
installation_850.qxd 9/10/99 6:26 PM Page 6
