Clarion UNGO MS2105, Installation Manual

Page: 16 / 32

-16-
15. System Test and Sensor Adjustment
15.1 System Test
1. Verify the Programmable Parameters are set.
2. Verify all wire connections are correct and secure.
3. Make sure none of the wires for the security system will interfere with safe
operation of the vehicle.
4. Test all functions of the vehicle, i.e. power door locks, power windows, lights,
etc.
5. Arm the security system; checking the siren chirps, parking lights, LED, and
door locks.
6. Disarm the security system; checking the siren chirps, parking lights, LED, door
locks, and dome light supervision.
7. Test all the entry points of the vehicle, doors, hood, and trunk/hatch. (Be sure
to test all doors.)
15.2 Dual Stage Sensor Test
1. Turn the ignition On.
2. Within 4 seconds, press the Shift Button (Button 5) 3 times, then Button 3.
The siren will chirp 4 times indicating the sensor is ready to be tested.
3. Test the sensitivity of the sensor by hitting various locations on the vehicle. (Do
hit the windshield or any other window. Be careful not to dent or damage any
parts of the vehicle during shock sensor testing.)
The siren will chirp when a trigger impact is detected.
One chirp indicates the shock sensor trigger.
Two chirps indicates the warn-away trigger.
Three chirps indicates the optional sensor.
4. To make shock sensor adjustments:
Turn the adjustment screw on the shock sensor clockwise to increase the
sensitivity.
Turn the adjustment screw on the shock sensor counter clockwise to
decrease the sensitivity.
5. Turn the ignition Off when the desired sensitivity level is reached.
MS2107 install.qxd 8/25/2003 12:50 PM Page 16