English
16
CZ702A
Notes of installation
1. Before installation, please make sure proper
connections are conducted and the unit
operates normally. Improper connection may
result in damage to the unit.
2. Use only accessories designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit in the place where
close to hot area to prevent damage to
electrical components such as the laser head.
5. Install the unit horizontally. Installing the unit
more than 30 degree vertically may result in
worse performance.
6. To prevent electric spark, connect the positive
pole first and then the negative pole.
7. DO NOT block the cooling fan exit to ensure
sufficient heating dissipation of this unit, or it
may result in damage to this unit.
Unit Installation
Method A
1. Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting tab
outwards with a screwdriver to fix the mounting
bracket in place.
2. Slide the unit into the bracket until you hear a
click sound.
Screwdriver
Stoppers
Hole
Instrument panel
Screw (M4x5)
Strap
Mounting bracket
Spring
Stoppers
Note:
Before attaching the mounting bracket, slightly bend the
spring toward the inside with your fingers and attach it to
the side of car.
Trim ring
Source Unit
Disassemble trim ring
1. Push the trim ring to right and pull out the
right part.
2. Push the trim ring to left and pull out the
left part.
Disassemble the unit
1. Switch off the power.
2. Remove the panel.
3. Remove the trim ring.
4. Insert the removal keys straight back until
they lock, then pull the unit out.
5. Disconnect all the wires.
Method B
6) Removing the Source Unit
Mounting Frame
Dashboard
M5x6
1. Insert this unit directly to the opening of
the dashboard.
2. Place M5×6 cylindrical screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.
Trim Ring Installation
Attach the trim ring around the front panel.
Take care of the top and bottom of the trim
ring and mount it so that all the hooks
are locked.
Top
Bottom
