26
27
Notes on installation
1. Before installation, please make sure
proper connections are conducted and the
unit operates normally. Improper connec-
tion may result in damage to the unit.
2. Use only accessories designed and manu-
factured for this unit. Other unauthorized
accessories may result in damage to the
unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit in close to hot
areas to prevent damage to electrical
components, such as the laser head.
5. Install the unit horizontally. Installing
the unit more than 30 degrees from the
horizontal plane may result in reduced
performance.
6. To prevent electric sparks, connect the
positive pole
fi
rst and then the negative
pole.
7. DO NOT block the ventilation opening
in the unit housing since this will prevent
proper heat dissipation and may result in
damage to the unit.
Unit Installation
Method A
1. Insert the mounting bracket into the dash-
board, choose the appropriate mounting
tabs according to the gap width, and bend
the mounting tabs outwards with a screw-
driver to
fi
x the mounting bracket in place.
2. Screw in the M4 × 42 stopper in the hole
on the back of the unit and put a rubber
sheath over the screw. (see picture below)
3. Slide the unit into the bracket until you hear
a click sound.
Screwdriver
Dashboard
Screwdriver
Rubber
Sheath
M4
×
42
Mounting
Bracket
Method B
1. Insert this unit directly to the opening of the
dashboard.
2. Insert M5 × 6 cylindrical screws through
the holes in the mounting frame into the
holes of the source unit and tighten on both
sides.
Trim Ring installation
Attach the trim ring around the front panel.
6) Removing the Source Unit
Disassemble the trim ring
1. Push the trim ring upward and pull out the
upper part.
2. Push the trim ring downward and pull out
the lower part.
Disassemble the unit
1. Switch o
ff
the power.
2. Remove the panel.
3. Remove the trim ring.
4. Insert the removal keys until they lock, then
pull the unit out.
5. Disconnect all the wires.
Mounting
Frame
M5
×
6
Dashboard
English
Polski
Français
Deutsch
Italiano
Nederlands
Español
Sv
ensk
a
Ελλ
ην
ικός
English
Polski
Français
Deutsch
Italiano
Nederlands
Español
Sv
ensk
a
Ελλ
ην
ικός
Downloaded from Caradio-Manual.com Manuals