English
18
CX305
NISSAN
TOYOTA
Examples 1-3
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with a
new one of the same specification as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• There are various types of fuse holder. Do not let the battery side touch other metal parts.
• After connection, fix the cord using a clamp or insulation tape for protection.
Mounting Screw Holes (Side View of the Main Unit)
Screws marked are included in the vehicle.
Note:
*1 Some panel openings are too small for the unit depending on the vehicle type and model.
In such a case, trim the upper and lower sides of the panel frame by about 0.5 to 1.5 mm so
the unit can be inserted smoothly.
*2 If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper
or similar tool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filling, etc.)
Typical Mounting Brackets
In some cases the center panel may require modification. (Trimming, filling, etc.)
Affix the screws to the marks.Affix the screws to the mark
Fuse (15A FUSE)
6-Spacer (thickness: 1 mm)
Mounting bracket
(1 pair for the left and right sides)
Mounting bracket
(1 pair for the left and right sides)
6-Flat head screw (M5 × 6)
(attached to the main unit)
8-Hexagonal screw (M5 × 6)
Center Panel *1
NISSAN
TOYOTA
Fuse holder
*
2
CX305 manual_ENG.indd 18
2015-1-30 13:59:43
