English
3
CC520
• This device has been designed
exclusively for use with a vehicular
mounted rear-view system. It should
not be used for other purposes.
• Disconnect the vehicle’s negative (-)
terminal when installing wiring.
• Do not attempt to disassemble or
modify this product.
• In the event it is necessary to drill holes
in the vehicle for mounting, confirm that
the drill bit or camera wiring will not
strike or interfere with piping, gas tank,
electrical wiring or other functional
parts of the vehicle.
• Do not rely solely on the monitor image
when reversing the vehicle.
The rear-view monitor is an auxiliary
device meant for confirming the
presence of obstacles to the rear of
the vehicle, and is limited in its range.
It should be used only in conjunction
with direct visual observations.
• Always reverse at low speeds.
The rear-view monitor produces a wide
angle image, with the result that
actual distances may be different than they
subjectively appear in the monitor.
• Do not use when the imaging surface or
other parts are malfunctioning.
• When installation and wiring are
completed, confirm that the vehicle’s
horn, brake and warning lights, and
other electrical equipment function
properly as designed.
WARNING
CAUTION
• Install only as directed in the Installation
Manual.
• Install accessory parts as directed.
• When drilling holes in the vehicle for
installation of wiring, always use
insulated grommets in the holes to
protect the wiring.
• If holes are drilled in the vehicle to
install the camera, or when installing
wiring, use silicon sealant to seal any
gaps.
• Do not damage or scar the camera
wiring.
• After completing the camera wiring,
use cable clamps or insulation tape
to bundle the wiring together.
• The images produced from the rear-
view monitor are inverted right-left
in the same way as images seen
in the vehicle’s rearview mirrors. The
image may differ depending on the
vehicle type.
• Do not use high-pressure car washing devices
around the camera.
The camera is a high-precision instrument and
should not be subjected to high-pressure water
stream impacts.
• Periodically check the tightness of
the installation screws and retighten
if necessary.
3. SPECIFICATIONS
Power source/voltage:
DC 12.0V (9 ~ 16V)
Power consumption:
<100mA (±20mA)
Image sensor:
1/4 inch Color CMOS sensor
Angle of view:
126 degrees (horizontal), 100 degrees (vertical)
Minimum subject illumination:
0.5 lux (at 50 IRE)
Active pixels:
322,752 (656 horizontal x 492 vertical)
Ingress Protection:
IP67
SN ratio:
38 dB (AGC ON) or better
Operating Temperature:
-40° C - +85° C
Dimensions:
23 (W) x 23 (H) x 22 (L) mm
Note: Specifications and design are subject to change without notice for further improvement.
Summary of Contents for CC520
Page 29: ......
