HDMI 8x8 Matrix Switcher User Guide
9
Save[Y].
Saves the present operation to the preset
command [Y]. [Y] ranges from 0 to 9.
Recall[Y].
Recalls the preset command [Y].
Clear[Y].
Clears the preset command [Y].
Notes
[x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged
according to the model of the matrix switcher. If the symbols exceed the
effective range, it would be taken as a wrong command.
In above commands, “[” and “]” are symbols for easy reading and do not
need to be typed in actual operation.
Please remember to end the commands with the ending symbols “.” and
“;”. Type the command carefully. Commands case-sensitive.
Example 1
Transfer signals from an input channel to all output channels: [x1]All.
e.g., “3All.” transfers HDMI from the input channel No.3 to all output channels.
Example 2
Transfer all input signals to the corresponding output channels respectively: All#.
e.g., "All#." results in input 1 to output 1, input 2 to output 2, input 3 to output 3,
and input 4 to output 4.
Example 3
Switch off all the output channels: All$.
e.g., "All$" results in no signal on any of the output channels.
Example 4
Check the version of the firmware: /^Version;
e.g., "/^Version;" returns the firmware version of the CM-MT8810-HD
Example 5
Switch off the detail feedback command from the COM port: /:MessageOff;
e.g., "/:MessageOff;" results in “switch OK” as the feedback for all commands.
Example 6
Switch on the detail feedback command from the COM port: /:MessageOn;
e.g., "/:MessageOn;" results in detailed feedback for all commands.
