CLARCOR UAS SFC Series, Owner'S Manual

Page: 24 / 40

19
revised 04/15
Sfc
cartridge Dust collector
if a drum lid quick release clamp was ordered, use
its clamping mechanism to secure the drum lid and
drum. to install the clamp: Before placing the drum lid
into place, open the clamp and slide it around the drum.
once the clamp is around the drum, install the drum lid
on top of the drum. after the drum lid is in place, slide
the clamp up and around the lip of the drum lid and
drum. once the clamp is around the lip of the drum,
pull the clamp close to secure the drum lid.
if a slide gate was ordered, it was factory installed on
the hopper. open the slide gate. repeat for multiple
drum lid connections.
NOTE: the hopper(s) is not designed for dust storage.
the slide gate should remain open during
normal operation.
3.6.6 INLET COVER AND BLANK COVER
PLATE INSTALLATION
inlet collar and blank cover plates bolt directly to
the Sfc unit. inlet and outlet collar assemblies
are specified with initial order; the dust collector is
supplied with all blank cover plates.
3.6.7 REMOTE BLOWER START/STOP
ASSEMBLY
a remote blower start/stop push button station is
available for field installation with Sfc systems
supplied with a uaS combination magnetic motor/
blower starter panel. the customer is required to
supply interconnecting field wiring and mounting
hardware for remote blower start/stop push button
station installation. refer to the DPM/DPc
Installation and Operation Manual .
FIGURE 14
SFC Explosion Vent Installation (Top Mount)
44-10365-0001