Pag. 2
Replace the battery holder in the housing; retighten the cap, checking that the seal is positioned correctly in its seat. Use only
2 new AAA 1.5 V alkaline batteries.
Once the batteries are fitted, an initialization routine will start (display Leds light up in sequence, valves close in sequence).
Warning: 30 seconds after having fitted the batteries or pressed any button, the Leds on the panel will go out. To refresh the
display, press any button.
INSTALLATION
Fit the timer to a cold water tap, following these simple instructions.
The spout of the tap should have a 3/4" or 1” male thread (if not, use an adapter)
Screw the ring nut of the 3/4" or 1” female fitting onto the tap.
Caution: tighten the ring nut using hand pressure only. Do not use wrenches or other tools. Connect the watering lines to the
respective quick-click or threaded fittings, using the appropriate connectors.
Remember to turn on the water tap!
+
+
b
b
c
c
a
a
RF 2-way timer
RF 2-way timer
User guide
User guide
For Aqua-Radio 2-way RF Timer (code): 90832
For Aqua-Radio 2-way RF Timer (code): 90832
1
1
1
1
2
2
3
3
2
2
1”
3/4”
click!
a
a
b
b
ON!
OK
OK
LOW
IP68
tested
b
b
a
a
OK
LOW
ONL
Y
ALK
ALINE
BATTER
Y
OK
LOW
