US
Programming
Changing a watering program
Repeat the programming procedure as indicated in
“Selecting a program”
on page 10
; the new program selected will replace the previous one,
with no further steps required.
Selection of Sequential/overlap mode
It’s preferible “but not necessary” to determine the operation
mode prior to setting the timer to avoid reprogramming.
The timer allows watering one line at a time (SEQUENTIAL mode) or both
lines simultaneously (OVERLAP mode).
To confirm or change the operation mode on which the timer is currently
set, proceed as follows:
1.
Press the
“a-StaRt”
and
“m”
buttons simultaneously.
2.
Within 5 seconds, the display will show the mode currently selected:
A
and
B
blinking alternately-> SEQUENTIAL mode
A
+
B
permanently lit -> OVERLAP mode
To
confirm the mode currently showing on the display, release the
“a-
StaRt”
and
“m”
buttons within 10 seconds.
To
change the mode (from SEQUENTIAL to OVERLAP and vice-versa),
wait at least 10 seconds, until the new mode appears in the display,
before releasing the
“a-StaRt”
and
“m”
buttons.
3.
Once the buttons are released, the timer resets by reverting back to the
OFF mode therefore all programs previously entered will be cancelled
while the mode just selected (SEQUENTIAL or OVERLAP) will be kept.
13
Summary of Contents for 8488 Dual Select
