claber 8488 Dual Select, Quick Start Manual, Page: 14 / 76

US
Programming
Delayed start
fig. 4C
C
h
A
B
m
h
Within 10 seconds of selecting a program,
press the
“a-StaRt”
button
repeatedly
to select line A, or the
“B-StaRt”
button to
select line B, until the display field
“C”
shows the required time delay, between
1-23 hours, before the opening of the
automatic watering cycle on the selected line
(fig. 4C).
The time delay will then blink 3 times, after which the program will begin the
countdown to the opening of the automatic watering cycle, shown in display
field
“C”
above the symbol .
If there is no watering cycle in progress, the display “C” shows
the countodwn to the opening of the next watering cycle as
well as the selected line.
Watering frequency and duration programmed on each line can be
displayed at any given moment by pressing the
“a-StaRt”
or
“B-StaRt”
button.
• If watering cycle is programmed on one line to start while the
other line is active, the timer will apply by deafult the “SE-
QUENTIAL” mode so that its activation will start at the time
that the previously programmed watering cycle is finished.
• Both lines can be programmed to operate simultaneously in the
“OVERLAP” mode, but make sure that water pressure supplied through
your faucet is sufficient. For setting the “OVERLAP”mode, read Selec-
tion of Sequential/Overlap Mode on page 13.
12