CLA-VAL
e-FlowMeter
Vortex Flow Meter
CLA-VAL
Europe
www.cla-val.ch
9
-
LIN041UE
C 11/20
© Copyright CLA-VAL Europe - Specifications subject to change without notice - no contractual illustrations.
Reduce your waste - Sort your rubbish
a)
Loosen knurled screw and remove locking collar from tool.
Remove tool and insert opposite end into the assembly.
(Fig.1 & 2)
b)
Turn gently until tool engages. Then push firmly until score
mark is flush with the face of the swivel insert assembly.
(Fig.3)
a) Remove insertion tool. Remove the protection cap by
pulling upright. (Fig.1)
b)
Reassemble e-FlowMeter by inserting the sensor assembly.
(Fig.2)
c)
Guide for the pin is positioned in the groove as show.(Fig.3)
Fully engage the sensor assembly and tighten the knurled
nut.
HAND TIGHT ONLY
.
d)
To orient the sensor assembly, loosen the headless screw
(Fig.3), orient the assembly as required then and tighten the
headless screw.
Proceed in accordance with wiring
diagrams
.
5
Fig.1
Fig.2
Fig.3
6
Fig.2
Fig.3
Pin
Headless screw
Fig.1
Mounting part B
