SM-A14448-A/2
2. INSTALLATION
9
2019-08-19
CAUTION
Do not use the product in a place where condensation occurs due to a sudden change in the
ambient temperature.
The customer is responsible for checking the compatibility of the product with the
customer
’s system, machinery, and device.
Connect only cables designed for the product.
A failure of the product or unexpected accident may occur.
Do not carry or install the product by holding its cable or the movable section.
An injury or cable disconnection may occur.
Secure sufficient space for maintenance and inspection.
Maintenance and inspection cannot be performed if sufficient space is not provided and this may
cause equipment stoppage, failure, or injury.
When holding the product, hold its bottom surface.
When transporting and installing the product, ensure the safety of the workers by securely
supporting the product using a lift or supporting gear and by assigning more than one
worker.
Install the product in a way that it is not subjected to twisting or bending force.
Before adjusting the gain, firmly secure the actuator body to a rigid device and mount the
jigs.
Do not hold the controller case tightly.
When using positioning holes, make sure to use pins having the size that does not require
press-fitting.
If press-fitting sized pins are used, the press-fitting load may cause the guide section to become
damaged or distortion may reduce accuracy. The recommended tolerance of the pin is JIS
tolerance of 6 µm or less.
When operating the product without supplying power, make sure to use the manual operation
plate.
Do not put dents and scratches on the body mounting surface and table surface that impair
their flatness and perpendicularity.
When there is a load fluctuation, hoisting/lowering operation (wall hanging installation), or
frictional resistance change, ensure a safe design that takes these into consideration.
These factors cause the operating speed to increase and may cause injuries to people and
damages to devices.
Achieve a safe design for the devices by taking into consideration the reduction in pressing
torque due to factors such as a power failure.
When the product is used with the clamp mechanism, the clamping force can decrease due to
factors such as a power failure and it can cause the workpiece to become detached. Make sure to
incorporate safety into the device design that prevents injuries to people and damages to devices.
