6. Using the enclosed Philips screwdriver, press the tip of the wall anchor through these two points and turn
clockwise until the anchor is flush with the wall.
7. Screw two of the Philips screws into the anchors. Back off the screws approximately 1/8” from the wall and
place the unit over the screws.
8. Mark the 2 holes for the bottom support bracket. Remove unit from the wall and repeat step 5.
9. Place the unit back over the two top screws. Screw the two remaining Philip screws into the bottom bracket
and tighten. Tighten the top screws.
CAUTION: Do not over-tighten the screws.
10. For masonry walls use a suitable lead or plastic shield and bolt. These shields are not supplied.
11. Remove the tape on the fuse holder, which is on the left side of the soak station.
12. Place labels on containers and insert into unit.
13. Display the laminated Probe Soaking Instructions on the wall in a visible location directly above or beside the
unit.
M0046_H
5
G10VPL
GUS Disinfection Soak Station™
