GUS
®
Model G14SD Instruction Manual
M0021_E
6
G14SD
Chapter 2 Installation and Setup
2.1 The 110 Volt Charcoal Fume Removal System Kit
MK01-0055, consists of the following items:
Item
Description
Quantity
Medivators Part Number
1
2-inch Hole Saw
1
MB03-0503
2
Vent Louver
2
MC13-0007
3
Screws
10
MS05-0045
4
Drill Template Side A and B
1
MT06-0506
5
Pilot Drill 0.144 (#27)
1
MB03-0504
6
Charcoal Fume Removal System
1
78399-219
2.2 Installation of adaptor box and G14SD
Tools needed:
Power Hand Drill
Philips Screwdriver
Tape
Vacuum
2.3 Installation Instructions
NOTE:
1. These instructions are for mounting the Charcoal Fume Removal System (CRFS) to
the DSD cabinet.
2. If the DSD already has the vent louver fitted proceed to step 2.3.8.
3. Wear proper protective gear during this procedure.
4. If the unit is already hard plumbed, call the facility maintenance personnel to
disconnect the unit.
5. Take extra care while moving the unit if the backside is hard to reach.
6. Unplug the unit before installation.
2.3.1
Open both lids of the unit and mask around the floating lids and the basin openings, as
much as possible, to prevent debris and plastic chips from falling inside the basin.
2.3.2
Remove the six center screws holding the hinge to the back plate of the unit, as shown in
figure 3.
Figure 3.
Remove center screws
