iDP-460 User’s Manual
10.2Command Sets
A command set is set by a specific command. The available commands and functions differ depending on
each setting.
(1) P-250 command set
There are two kinds of modes; P-200 mode and P-250 mode. The P-900R mode are available with a P-900R
mode and P-250 mode command. The SI, SO, RS, US, and DC2 command operate differently between the
P-200 mode and P-250 mode.
In the P-200 mode, if the 40th character in the line is received, the contents of the buffer will be printed
automatically. In the P-250 mode, the default delimits at the 42nd character and printing is performed only
after the LF command is received.
(2) P-900R command mode
Basically, this mode is the same as the P-250 mode. It can be set by a command. With the serial interface,
if a paper end error is detected in this mode, "#" will be output as the TD signal every second until the paper
end error is reset.
