BD2-2860 User’s Manual
CITIZEN
12
CAUTION:
1.
For LED of ERROR and PE, there is a resister of 330
Ω
on the circuit side to make current
value 10mA.
Please use LED which its voltage is approx. 2V. LED over 10mA may break a control board.
2.
Control circuit requires power supply only for one pin of each VCC and GND.
However, Operation voltage is to be supplied to all of pin for safety use.
3.
Serial interface equips a driver and receiver of RS-232C, make sure to use it at RS-232C
level.
4.
RESET terminal is pulled up by 3.3KW. Make sure to make this terminal NC, when this
terminal is not used.
5.
LF-SW input circuit is as below.
3.4 CN4 Connector for Paper Cutter
Pin No.
Signal Name
I/O
Function
1
M +
Output
Cutter motor operational signal M +
2
M
–
Output
Cutter motor operational signal M
–
3
GND
–
GND
4
SW
Input
Cutter switch input signal
Using Connector : 5207-0410A (Molex)
Note ) Use the specified Paper Cutter(Model Name : ACS-220-5V)
Summary of Contents for BD2-2860
