7
tubing is in the fluid, not above the fluid.
Note: Do not run the pump without fluid
passing through the tube. This can cause damage to the pump and is not covered
under warranty.
2.
If the green “READY” light does not come on:
a. Check fuse and switch light to verify that power is on.
b. The thermal cut-out switch may need reset if unit was previously overheated.
Call your dealer for assistance with this problem.
3.
If the LED display shows an error:
There are two possible error conditions, resulting in
the display reading E2 or E3. The unit will not operate if any of these error conditions
exist.
a.
E2
- The thermal sensor is not connected. This is a safety feature and is not
customer accessible. Call CITC for more information.
b.
E3
- The thermal sensor input is shorted. This is also a safety feature and not
customer accessible. Call CITC for more information.
6.
Maintenance and Storage
Care of your AQUAMAX™ MP will give you years of service. Note:
cleaning your unit is going to pay off in constant good performance.
1.
Dry all areas on the exterior of the machine once it is cool. Clean with a soft cloth to
remove any haze fluid from inside the fluid compartment or outside area.
2.
Clean thoroughly around the output area of the AquaMax™ MP. Heavy use and certain
air conditions may cause a slight build-up of haze fluid in that particular area.
3.
Do not store with haze fluid inside. When placing into storage, or following periods of
heavy use, clean the tube and pump by operating the unit while running a pint of 5%
vinegar/distilled water mix through the pump, and then rinse with a pint of distilled water.
When finished, water should remain in the line for storage. Do not drain or empty the tube
of water unless a freezing condition exists. Do not run the pump without fluid passing
through the tube. This can cause damage to the pump and is not covered under
warranty.
4.
Do not transport or ship with haze fluid inside the machine.
