5
not add other equipment on this circuit. If you have any doubts about the capacity or
grounding of your existing circuits, consult a qualified electrician.
5.3
Hooking things up
Plug the 5-pin XLR of the Remote Control into the inlet marked “Remote Control Input”.
Fill the bottle with CITC’s Organic Haze
TM
fluid. Place the filter end of the tube inside the
bottom of the bottle and tighten cap. Be sure the vent hole in the cap is not blocked.
5.4
Operating the AQUAMAX™ MP using the Remote Control
1.
Turn on the power switch on the hazer. Verify that
the red light in the switch, the display on the rear
panel of the AQUAMAX™ MP, and the red
“POWER” light on the Remote all come on. Wait
approximately 5-6 minutes for the green "READY"
light located on the remote control to come on.
2.
Using the
red
"VARY OUTPUT" button, you may
adjust the output volume with the “OUTPUT”
control KNOB.
3.
Using the
yellow
“TIMER KNOBS” button, you
may adjust the "ON" and "OFF" knobs to set the
haze cycle times. NOTE: Do not depress "VARY
OUTPUT" when using timer. To prime the pump if
your AQUAMAX™ MP has run dry, depress the
black pump priming button that is on the panel by
the lighted on/off switch. You should not need to
hold it in for more than a few seconds to see the
fluid go into the machine. DO NOT operate
continuously using the “PRIME” button. This can
cause your AquaMax™ MP to cool down, spit wet
fluid, or result in louder and wetter output.
o
By quickly depressing the
green
“FAN” button,
you will be able to change the speeds of the
onboard fans. The display on the AQUAMAX™
MP rear panel will illuminate to indicate fan speed
(F1, F2, and F0). Press and release quickly once for Low and twice for High. Press again
for “off”. After 5 seconds, the display will reset to show the DMX channel.
4.
On remote, the fans will continue to operate at their current settings for an additional 60
seconds after the fluid pump has stopped in order to clear out residual haze.
