8 |
www.
cistermiser
.co.uk
6. Advanced settings guide
Carry out only if settings need to be changed
1
Disconnect power, wait for 5 seconds and reconnect.
You are now in configuration mode
When
flashing amber
Place hand 4-6cm from
sensor until
constant green
.
Then remove hand.
Sensing range adjustment
Wait for
single
red flashing
LED
to enter sensing
range mode
A
Briefly place your hand in front
of the sensor until the
green
LED flashes slowly
. Range
configuration mode will then be
ready
B
Move your hand to the distance from the sensor you would like to
set as maximum range. Wait 8 seconds until
constant green
shows
C
Run-on time adjustment
Wait for
double
red flashing
LED to enter
run-on time
A
Sensor distance
is now set
When the water has run for the desired run-on time, move your hand out of the line
of sight of the sensor. The water will cease and the run-on time will be set.
C
4
After configuration the unit will
flash amber
giving opportunity to
re-enter configuration mode
B
During
double red flashing
briefly place your hand in
front of the sensor, water
will start running while a
green flashing
will be seen.
HOLD HAND STEADY
3
x 2
If a hand is not placed over the sensor, it will go into normal operation mode.
AMBER
2
GREEN
GREEN
AMBER
RED
RED
GREEN
GREEN
A
When the water has run for the desired run-on time, move your hand out of the line
of sight of the sensor. The water will cease and the run-on time will be set.
C
B
RED
GREEN
12hr hygiene rinse cycle activation
Wait for
triple
red flashing
LED to enter
hygiene rinse
activation
x 3
During
triple red flashing
place your hand in front of the
sensor.
Single green flash
=
on.
Double green flash
=
off.
To change state briefly move your hand away
and replace in front of the sensor again.
