15
Chapter 5: Configuring the Wireless-G Travel Router with SpeedBooster
The Setup Tab - Basic Setup
Wireless-G Travel Router with SpeedBooster
Router IP
IP Address and Subnet Mask
. This shows both the Router’s IP Address and Subnet Mask, as seen by your
network. The default IP Address is
192.168.16.1
, and the default Subnet Mask is
255.255.255.0
. In most cases,
keeping the default values will work.
DHCP Server Setting
The settings allow you to configure the Router’s Dynamic Host Configuration Protocol (DHCP) server function. The
Router can be used as a DHCP server for your network. A DHCP server automatically assigns an IP address to
each computer on your network. If you choose to enable the Router’s DHCP server option, you must make sure
there is no other DHCP server on your network.
DHCP Server
. DHCP is enabled by factory default. If you already have a DHCP server on your network, or you
don’t want a DHCP server, then select
Disabled
(no other DHCP features will be available).
Static DHCP
. Every time a PC reboots, it is assigned a new local IP address by the Router. If you want a PC to be
assigned the same IP address every time it reboots, then click the
Static IP
button.
On the
DHCP Client List
screen, enter the static local IP address in the
Assign this IP
field, and enter the MAC
address of the PC in the
To this MAC
field. Then click the
Enabled
checkbox. When you have finished your entries,
click the
Save Settings
button to save your changes. Click the
Cancel Changes
button to cancel your changes.
To exit this screen, click the
Close
button.
If you want to see a list of DHCP clients, click the
DHCP Client Table
button. On the
DHCP Client Table
screen, you
will see a list of DHCP clients with the following information: Client Name, Interface, IP Addresse, and MAC
Addresse. To save the information, select
Static DHCP Client List
. From the
To Sort by
drop-down menu, you can
sort the table by Client Name, Interface, IP Address, or MAC Address. To view the most up-to-date information,
click the
Refresh
button. To exit this screen, click the
Close
button.
Start IP Address
. Enter a value for the DHCP server to start with when issuing IP addresses. Because the
Router’s default IP address is 192.168.16.1, the Starting IP Address must be 192.168.1.2 or greater, but smaller
than 192.168.1.254. The default Starting IP Address is
192.168.16.100
.
Maximum Number of Users
. Enter the maximum number of PCs that you want the DHCP server to assign IP
addresses to. This number cannot be greater than 253. The default is
50
.
IP Address Range
. The range of DHCP addresses is displayed here.
Client Lease Time
. The Client Lease Time is the amount of time a network user will be allowed connection to the
Router with their current dynamic IP address. Enter the amount of time, in minutes, that the user will be “leased”
Figure 5-9: Static DHCP Client List
Figure 5-10: DHCP Client Table
