Cisco vEdge 100, Hardware Installation Manual

Page: 12 / 260

Table 3:
Behavior Press
Duration
Pressing for two seconds resets and reboots the router. Short press
Pressing for 10 seconds resets the router and reboots it with factory default configuration. Long press
Kensington Security Lock Slot
The rear panel of the vEdge 100 router has a small metal-enforced hole for attaching a Kensington lock to
secure the router.
GPS Input
The GPS antenna input on the rear panel of the router allows you to connect an external GPS antenna that has
an SMA connector. If you connect a GPS antenna to the router, it can automatically identify the router's
geographical location.
Ports and Connectors
The vEdge 100 router supports three types of ports: RJ-45 Ethernet ports, USB port, and USB serial console
port.
RJ-45 Ethernet Ports
There are five built-in RJ-45 Ethernet ports on the vEdge 100 router. These ports support 10/100/1000 Mbps
and are numbered 0 through 4. Port 0 supports PoE capability.
Figure 1 provides the pinout information for the RJ-45 ports. The RJ-45 ports comply with the 801 standards.
Figure 1: RJ-45 Ports Pinout Information
USB Port
There is one USB port on the vEdge 100 router with a type A connector. The USB port complies with USB
3.0 specification.
Hardware Installation Guide for vEdge Routers
6
vEdge 100 Router
Ports and Connectors