S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
11
Cisco UCS B440 High Performance Blade Server Installation and Service Note
OL-22475-01
Installing and Removing a Blade Server Hard Drive
Hard disk and RAID troubleshooting information is in the
Troubleshooting Server Hardware
chapter of
the
Cisco UCS Troubleshooting Guide
. The B440 uses an LSI SAS 2108 RAID controller (the onboard
version of the LSI MegaRAID 9260).
Table 3
shows the drives supported in this blade server.
Removing a Blade Server Hard Drive
To remove a hard drive from a blade server, follow these steps:
Step 1
Push the button to release the ejector, and then pull the hard drive from its slot. (See
Figure 3
.)
Step 2
Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in
another blade server.
Step 3
Install a blank faceplate (N20-BBLKD) to keep dust out of the blade server if the slot will remain empty.
Table 3
Supported Hard Disk Drives (HDD)
Product ID
Description
A03-D073GC2
73 GB, 6Gb SAS transfer rate, 15K RPM HDD/hot plug/drive sled mounted
A03-D146GC2
146 GB 6Gb SAS transfer rate, 15k RPM SFF HDD/hot plug/drive sled mounted
A03-D300GA2
300 GB, 6Gb SAS transfer rate, 10K RPM HDD/hot plug/drive sled mounted
A03-D100SSD
100 GB SATA SSD HDD/hot plug/drive sled mounted (no longer sold)
UCS-SSD100GI1F104
100 GB SATA SSD HDD/hot plug/drive sled mounted
A03-D600GA2
600 GB, 6Gb SAS transfer rate, 10K RPM HDD/hot plug/drive sled mounted
UCS-HDD300GI2F105
300GB 6Gb SAS 15K RPM SFF HDD/hot plug/drive sled mounted
1
1.
This drive requires UCS capability catalog version 1.0.50.T or 2.0.1nT or later.
UCS-HDD900GI2F106
900GB 6Gb SAS 10K RPM SFF HDD/hot plug/drive sled mounted
2
2.
This drive requires UCS capability catalog version 1.0.54.T or 2.0.1pT or later.