— 5 —
B
Connecting the touch screen directly to the codec
Note:
To be able to use this option you need a codec with two Ethernet/LAN
connectors.
1.
Enable
Direct pairing
on the codec. Navigate to
Home > Settings > Administrator
settings > Pairing
with the remote control to switch it on, or configure the
NetworkPort 2 > Mode
setting via the web interface or the command line
interface.
Note:
The codec’s first Ethernet connector must be connected to LAN.
The codec is required to reboot for this change to take effect.
2.
Connect the touch screen cable to the Power adapter.
3.
Connect the shielded Ethernet cable between the Power adapter and the
second Ethernet connector on your codec.
CAUTION:
Do not connect the codec’s second Ethernet connector to LAN.
4.
Connect the supplied power cable between the Power adapter and the power
socket. Once power is connected, the touch screen start-up procedure begins.
If required, the touch screen downloads and installs new software from the codec.
The touch screen automatically restarts after the software upgrade. This process
may take a few minutes.
Continue when the menu and contact list appear on the touch screen.
7.5 m
5 m
1.8 m
Power
adapter
On a Profile system the
codec is placed inside the
foot module.
Power socket
Connect to the
codec’s second
Ethernet connector