Cisco Small Business RV320, Administration Manual

Page: 77 / 122

Firewall
Access Rules
Cisco RV320/RV325 Administration Guide 77
7
Adding an Access Rule to the IPv4 Access Rule Table
To add (or edit) an IPv4 access rule:
STEP 1
Click the IPv4 tab.
STEP 2
Click Add (or select the row and click Edit ).
STEP 3
Select the Action, Allow or Deny , for this rule from the drop-down menu.
STEP 4
Select a Service from the drop-down menu.
STEP 5
Select Log packets matching this rule or No Log .
STEP 6
Select the Source Interface from the drop-down menu.
STEP 7
Select the Source IP address from the drop-down menu. If you selected Single ,
enter the source IP address. If you selected Range , enter the range of source IP
addresses.
STEP 8
Select the Destination IP address from the drop-down menu. If you selected
Single , enter the destination IP address. If you selected Range , enter the range of
destination IP addresses.
STEP 9
Configure the Scheduling for this access rule by selecting the time. Select
Always for the access rule to be in effect 24 hours a day. Select Interval to set a
time, and enter the hours and minutes that the access rule is effective in the From
and To fields. For example,
07:00
to
20:00
. The access rule does not allow
setting two time intervals.
STEP 10
Select the Effective On days of the week.
STEP 11
Click Save .
Adding an Access Rule to the IPv6 Access Rule Table
To add (or edit) an IPv6 access rule:
STEP 1
Click the IPv6 tab.
STEP 2
Click Add (or select the row and click Edit ).
STEP 3
Select the Action, Allow or Deny , for this rule from the drop-down menu.
STEP 4
Select the Service from the drop-down menu.
STEP 5
Select the Log from the drop-down menu.