Cisco PrecisionHD 1080p12x, User Manual

Page: 29 / 37

Cisco TelePresence PrecisionHD Camera
D14640.12 Cisco Telepresence PrecisionHD Camera User Guide TC6.2, August 2013.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
29
User Guide
The VISCA™/RS–232 control protocol, cont...
NOTE: Some VISCA™ commands do not apply to the PrecisionHD 1080p2.5x/4x/4x S2 cameras.
Network and interface commands
Push messages
Messages sent from camera to controller.
Command set Command packet Comments
IF_Clear 8x 01 00 01 ff Clear command buffer. Stop any current operation
in progress.
Address_Set 8x 30 0p ff p = address for this device. If x=8 (broadcast),
increase p with 1 before sending to chain.
Command_Cancel * 8x 2p ff p = Socket ID. PrecisionHD 1080p 12x does not
support multiple sockets. Commands always runs
to completion. Do not use it.
Command set Command packet Reply and comments
Network_Change y0 38 ff This indicates that cameras have been added to
or removed from the chain.
It is recommended to wait 9 seconds after
receiving this message before doing a full
reconfigure.
IR_Push y0 07 7d 02 gg hh ff If IR mode is on, IR codes received by the
camera are sent to the controller.
gg = IR ID
hh = keycode
* Does not apply to PrecisionHD 1080p2.5x/4x/4x S2 cameras
Command Command Packet Comments
Power_On 8x 01 04 00 02 ff Power control. This command stores
the zoom and focus value and reset
these motors.
Used for PrecisionHD 720p if the
camera has been on for a long time.
Puts the PrecisionHD 1080p camera to
standby mode.
Power_Off 8x 01 04 00 03 ff
Video_Format 8x 01 35 0p 0q 0r ff Selects video format.
p = reserved
q = video mode. See the video format
table:

Video mode selection .
r = Used in PrecisionHD 720p camera.
Can be recycled.
WB_Auto 8x 01 04 35 00 ff WB: White Balance
WB_Table_Manual 8x 01 04 35 06 ff
WB_Table_Direct 8x 01 04 75 0p 0q 0r 0s ff Used if WBmode = Table manual pqrs
= wb table.
AE_Auto 8x 01 04 39 00 ff AE: Automatic Exposure.
AE_Manual 8x 01 04 39 03 ff
Iris_Direct 8x 01 04 4B 0p 0q 0r 0s ff Used if AE mode = Manual. pqrs: Iris
position, range 0..50
Gain_Direct 8x 01 04 4c 0p 0q 0r 0s ff Used if AE mode = Manual. pqrs: Gain
position, values:12-21dB.
Backlight_On 8x 01 04 33 02 ff BacklightCompensation mode
Backlight_Off 8x 01 04 33 03 ff
Camera commands
Contents Introduction The Physical Interface Connecting the Camera Appendices Daisy Chaining Video Output Format Appendices