Cisco Physical Access 1125 Appliance, User Manual

Page: 22 / 42

3-4
Cisco Physical Access 1125 Appliance User Guide
OL-20929-01
Chapter 3 Rack Mounting the Cisco PAM 1125 Appliance
Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-2 Fastener Pack Contents
211431
1 2 3 4 5 6
Table 3-3 describes the fasteners that are shown in Figure 3-2 .
Table 3-3 Fastener Pack Contents
Callout Hardware Description Quantity
1 Screw, #10-32 x ½-inch (rack screw) 8
2 Screw, hex head 4
3 Screw, #10-32 x 7/8-inch 2
4 Handle spacers (not used) 2
5 Nut bar (not used) 4
6 Chassis disks (not used) 2
Mid-Mounting the 1125 Appliance on a Two-Post Rack
This section contains the following topics:
•
Attaching Brackets to the Chassis, page 3-4
• Attaching L Brackets to Center Posts, page 3-6
•
Installing the Chassis in the Rack, page 3-7
Attaching Brackets to the Chassis
Before you begin, check the #10-32 x ½-inch screws that are included in the Fastener Pack to see if they
are the correct size for your rack. If not, obtain the correct screws to use in the procedure where “rack
screws” are required.
To attach brackets to the chassis, perform the following procedure:
Step 1 Remove the chassis handles by removing the two screws (see Figure 3-3 on page 3-5 ) from each handle.
Then, replace the screws to keep the bezel attached to the appliance.