4-16
PA-A2 ATM CES Port Adapter Installation and Configuration
OL3460-01
Chapter 4 Configuring the PA-A2 ATM CES Port Adapter
Checking the Configuration
Using show Commands to Verify the New Interface Status
This section demonstrates how you can use the show commands to verify that new interfaces are
configured and operating correctly and that the port adapter appears in them correctly. Sample displays
of the output of selected show commands appear in the sections that follow. For complete command
descriptions and examples, refer to the publications listed in the
“Related Documentation” section on
page viii
.
If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections:
•
Using the show version or show hardware Commands, page 4-16
•
Using the show diag Command, page 4-17
•
Using the show interfaces Command, page 4-17
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the Cisco
IOS software version, the names and sources of configuration files, and the boot images using the
show version (or show hardware) command.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7200 Series Routers—Example Output of the show version Command
Following is an example of the show version command from a Cisco 7200 series router:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-IS-M), Version 12.2(8)B, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 02-Aug-02 10:51 by ccai
Image text-base: 0x60008940, data-base: 0x61850000
ROM: System Bootstrap, Version 11.1(13)CA, EARLY DEPLOYMENT RELEASE SOFTWARE (f)
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 11.1(16)CA, EARLY DEPLOYMENT REL
d11-5-7206-15 uptime is 1 week, 31 minutes
System returned to ROM by reload at 14:08:34 UTC Tue Aug 20 2002
System image file is "slot0:c7200-is-mz.122-11.T"
cisco 7206 (NPE200) processor (revision B) with 114688K/16384K bytes of memory.
Processor board ID 15455885
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
6 slot midplane, Version 1.3
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
