Cisco ONS 15454 SDH, Procedure Manual

Page: 129 / 860

4-13
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 4 Turn Up a Node
NTP- D34 Set Up SNMP
Step 4
Complete the following in the Create SNMP Trap Destination dialog box ( Figure 4-3 ):
• Destination IP Address—Type the IP address of your network management system. If the node you
are logged into is an end network element (ENE), set the destination address to the GNE.
•
Community—Type the SNMP community name. For a description of SNMP community names,
refer to the “SNMP” chapter in the
Cisco ONS 15454 SDH Troubleshooting Guide .
Note
The community name is a form of authentication and access control. The community name
assigned to the ONS 15454 SDH is case-sensitive and must match the community name of
the network management system (NMS).
•
UDP Port—The default User Datagram Protocol (UDP) port for SNMP is 162. (More information
about provisioning the UDP port is also given in the
“DLP-D151 Set Up SNMP for a GNE” task on
page 18-43 and “DLP-D153 Set Up SNMP for an ENE” task on page 18-45 .)
• Trap Version—Choose either SNMPv1 or SNMPv2. Refer to your NMS documentation to determine
whether to use SNMP v1 or v2.
Figure 4-3 Creating an SNMP Trap Destination
Step 5
Click OK . The node IP address of the node where you provisioned the new trap destination appears in
the Trap Destinations area.
Step 6 Click the node IP address in the Trap Destinations area. Verify the SNMP information that appears in
the Selected Destination list.
Step 7
If you want to set up SNMP remote monitoring (RMON) on GNEs and ENEs, complete the following
DLPs as required, depending on the protection groups that you want to create:
• DLP-D151 Set Up SNMP for a GNE, page 18-43
•
DLP-D153 Set Up SNMP for an ENE, page 18-45
• DLP-D162 Format and Enter NMS Community String for SNMP Command or Operation, page
18-52
Step 8
Click Apply .
Stop . You have completed this procedure .