S e n d f e e d b a c k t o n e x u s 4 K - d o c f e e d b a c k @ c i s c o . c o m
8
Cisco Nexus 4001I and 4005I Switch Module for IBM BladeCenter Getting Started Guide
OL-19952-02
Configuring the Switch
IPv4 address of the default gateway: <
IP address
>
Step 10
Enable the Telnet service by entering
yes
(or
y
), as in the following example:
Enable the telnet service? (yes/no) [y]:
y
Step 11
Enable the SSH service by entering
yes
(or
y
), as in the following example (the default is no):
Enable the ssh service? (yes/no) [n]:
n
Step 12
Configure the NTP server by entering
yes
(or
y
), as in the following example (the default is no):
Configure the ntp server? (yes/no) [n]:
n
Step 13
Configure the FCOE service by entering
yes
(or
y
), as in the following example (the default is no):
Enable FCOE service? (yes/no) [n]:
n
After the prompt for the FCOE service, the configuration appears, as in the following example:
The following configuration will be applied:
username qatest password <user-password> role network-operator
snmp-server community topspin ro
switchname ibm-switch-1
interface mgmt0
ip address 10.10.10.1 255.255.255.0
no shutdown
ip route 0.0.0.0/0 10.10.10.100
telnet server enable
no ssh server enable
Would you like to edit the configuration? (yes/no) [n]:
Use this configuration and save it? (yes/no) [y]:
y
Step 14
If you want to make changes to the displayed configuration, enter
yes
(or
y
); otherwise accept the default
(no) by pressing
Enter
.
If you enter
yes
, the setup utility returns to the beginning of the setup, and repeats each step.
Step 15
Save this configuration by entering
yes
(or
y
), as in the following example (the default is no):
Use this configuration and save it? (yes/no) [y]:
y
ibm-switch-1 #
If you do not save the configuration at this point, none of your changes are part of the configuration the
next time the device reboots. Saving the configuration also automatically configures the boot variables
for the kickstart and system images.
Note
The switch module has two out-of-band management interfaces. The AMM configuration is mgmt1. The
mgmt0 interface must be placed on a different subnet than mgmt1.
