S e n d f e e d b a c k t o n e x u s 4 K - d o c f e e d b a c k @ c i s c o . c o m
7
Cisco Nexus 4001I and 4005I Switch Module for IBM BladeCenter Getting Started Guide
OL-19952-02
Configuring the Switch
Note
Register the switch module device immediately with your supplier. Failure to register may affect
response times for the initial service call. The device must be registered to receive entitled
support services.
Step 3
Enter the basic configuration information.
The following example shows how to start the basic configuration setup:
n4k-8#
setup
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup is mainly used for configuring the system initially,
when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Step 4
Enter the setup mode by entering
yes
(or
y
), as in the following example:
Would you like to enter the basic configuration dialog (yes/no):
yes
Step 5
(Optional) Create additional accounts by entering
yes
(or
y
), as in the following example (no is the
default):
Create another login account (yes/no) [n]:
y
Enter the User login Id: <
ID
>
Enter the password for "qatest": <
password
>
Confirm the password for "qatest": <
password
>
Enter the user role [network-operator]: <
role
>
Step 6
(Optional) Configure an SNMP community string by entering
yes
(or
y
), as in the following example (no
is the default):
Configure read-only SNMP community string (yes/no) [n]:
y
SNMP community string: <
string
>
Step 7
Enter a name for the switch, as in the following example:
Enter the switch name:
ibm-switch-1
Step 8
Configure out-of-band management by entering
yes
(or
y
), as in the following example:
Continue with Out-of-band (mgmt0) management configuration? (yes/no) [y]:
y
Mgmt0 IPv4 address:
10.10.10.1
Mgmt0 IPv4 netmask:
255.255.255.0
Step 9
Configure the IPv4 default gateway (recommended) by entering
yes
(or
y
). Enter the gateway IP address.
Configure the default gateway? (yes/no) [y]:
y
