g) Verify that the power supply is functioning by making sure that the OK LED turns green and the FAULT LED is
off.
Step 3
Listen for the fans; they should begin operating when the power cable is plugged in.
Step 4
After the switch boots, verify that the following LEDs are on:
•
Power supply LED
—
lit and green
If not green, try removing the module part way from its slot and reinstalling it.
•
Fan LED
—
lit and green
If not green, try removing the module part way from its slot and reinstalling it.
•
System Status LED
—
lit and green (if this LED is orange or red, then one or more environmental monitors is
reporting a problem.)
•
Link LEDs for the Ethernet connector
—
Off
Cisco Nexus 3600 Hardware Installation Guide
20
Installing the Chassis
Starting the Switch
